CEMA Coating & Laminating Fundamentals

AIMCAl & CEMA will be sponsoring a Seminar on Coating & Laminating. The schedule is below. For more information and to register go to
        www.AIMCAL.ORG

                    Coating and Laminating Fundamentals for Converters
                                    Sponsored By CEMA
                                    April 15-15 2008
                                    Charlotte, N.C.

DAY 1     TUESDAY, 4/15/2008

    
   

8:20    Introduction and Welcome
    Doug Krasucki, R.D. Specialties, Inc.
8:30    Substrate Cleaning and Prep
    Dr. Ken McCarthy Clean Room Coating Solutions
9:00    Overview of Fluid Delivery Systems
    Dr. Ken McCarthy Clean Room Coating Solutions
9:30    Substrate Surface Treatment Options
    Tom Gilbertson, Enercon

10:00    Break

10:30    Coating Methods - Overview
    Ed Cohen, Ed Cohen Consulting
11:00    Coating Methods - Hot Melt
    Bob Dages, Kroenert
11:30    Coating Methods - Roll Coating
    Bob Dages, Kroenert

12:00     Lunch

1:00    Coating Methods - Mayer Rod Coating
    Doug Krasucki, R.D. Specialties, Inc.
1:30    Coating Methods - Pre-Metered
    Jeff Seckora, Extrusion Dies Industries
2:00    Coating Methods - Vacuum
    Liz Josephson, Applied Materials
2:30    Laboratory & Pilot Coating Technology
    Ed Cohen, Ed Cohen Consulting

3:00    BREAK

3:15    Laminating - Keys to Laminating Success
    Tim Walker, TJ Walker & Associates
4:30    Web Coating Defects – Control and Measurement
    Tim Potts, Dark Field Technologies

5:00    TableTop Reception

   
   

ay 2 Wednesday    16-Apr-08
8:20    Day Two Introduction
    Doug Krasucki, R.D. Specialties, Inc.
8:30    Basic Industrial Drying Methods
    Richard Luedtke of Radiant Energy Systems
9:00    Optimizing Your Dryer’s Performance
    Dan Bemi, MEGTEC Systems
9:30    Successful UV Processing on Heat Sensitive Substrates
    Juliet Midlik, Prime UV/IR Systems

10:00    BREAK

10:30    On-Line Coating Weight Measurement
    Ted Schnackertz,  NDC Infrared Engineering
11:00    Web Guide Selection and Application
    Ron Schmidt, Fife Corporation
11:30    Web Tension and Tension Control Systems
    Darrell Whiteside, MAGPOWR

12:00    Lunch

1:00    Web Spreading
    Jeff Damour, Converter Accessory Corporation
1:30    Rollers - Overview
    Michael McGovern, American Roller Bob Russel
2:00    Air Shafts / Ergonomics
    Sean Craig, Tidland Corporation
2:30    Roller Alignment
    Fritz Williams, Oasis Alignment

3:00    Close

Comments

[paper machines]

I have one of the 1200E cutters, I bought it for my school's office and it has lasted! I love it, and would highly recommend it.